Search results for "CHEMICAL ACTIVATION"
showing 4 items of 4 documents
Suitability of Illite Based Clays of Latvia for Chemical and Thermal Activation
2014
Materials has been synthesized in the temperature range from 600-800 0C from illite based clays of Latvia under activation of KOH and NaOH solutions (4-6 M). Compressive strength and apparent porosity were measured. The effect of the concentration of KOH and NaOH solutions on the material mechanical properties was investigated by means of infrared spectroscopy (IR). Compressive strength data of the materials showed that via such activation building materials with good quality can be obtained.
Electrochemical performance of activated screen printed carbon electrodes for hydrogen peroxide and phenol derivatives sensing
2019
Screen-printed carbon electrodes (SPCEs) are widely used for the electroanalysis of a plethora of organic and inorganic compounds. These devices offer unique properties to address electroanalytical chemistry challenges and can successfully compete in numerous aspects with conventional carbon-based electrodes. However, heterogeneous kinetics on SPCEs surfaces is comparatively sluggish, which is why the electrochemical activation of inks is sometimes required to improve electron transfer rates and to enhance sensing performance. In this work, SPCEs were subjected to different electrochemical activation methods and the response to H2O2 electroanalysis was used as a testing probe. Changes in to…
Effects of pyrolysis conditions on the porous structure development of date pits activated carbon
2012
International audience; Activated carbons were prepared from biomass of Algerian date pits for developing efficient and cheap adsorbents in the aim to remove heavy metals from waste water. Carbon adsorbents were obtained following two successive treatments: pyrolysis under dry nitrogen flow and physical activation under wet nitrogen flow. Pyrolysis process was optimized by varying some operating parameters such as temperature, nitrogen flow, heating rate and pyrolysis hold time in order to determine their effects on the porous structure development of date pits activated carbon. Chars obtained from pyrolysis process were activated with the same operating conditions (activation temperature o…
Highly activated screen-printed carbon electrodes by electrochemical treatment with hydrogen peroxide
2018
An easy effective method for the activation of commercial screen-printed carbon electrodes (SPCEs) using H2O2 is presented to enhance sensing performances of carbon ink. Electrochemical activation consists of 25 repetitive voltammetric cycles at 10 mV s−1 using 10 mM H2O2 in phosphate buffer (pH 7). This treatment allowed us to reach a sensitivity of 0.24 ± 0.01 μA μM−1 cm−2 for the electroanalysis of H2O2, which is 140-fold higher than that of untreated SPCEs and 6-fold more than screen-printed platinum electrodes (SPPtEs). Electrode surface properties were characterized by SEM, EIS and XPS. The results revealed atomic level changes at the electrode surface, with the introduction of new ca…